Switch Bezel Removal/Installation

Reply Subscribe

Thread Tools

Search this Thread

Nov 25, 2009 | 12:33 PM

tompmatthews

Thread Starter

New User

Joined: Nov 2009

Posts: 14

Likes: 0

From: Reno, NV

Switch Bezel Removal/Installation

I have a 1955 Ford F100 that I am changing some of the dash switches on. Things like the ignition switch and light switch. The switch bezels have two opposing grooves which I assume takes a special tool to remove them. Does anyone know where I can buy a tool? Or, how can I remove the bezels without the tool?

Nov 25, 2009 | 12:42 PM

fking1

Elder User

Joined: Jul 2004

Posts: 825

Likes: 3

From: Michigan

Needle nosed pliers or use a screw driver in one groove and bump the driver.
Channel locks on the outside edge gently applied.

Nov 25, 2009 | 12:48 PM

Dr G

Senior User

Joined: Sep 2009

Posts: 289

Likes: 3

From: Van Nuys, CA

Quote:

Originally Posted by fking1

Needle nosed pliers or use a screw driver in one groove and bump the driver.
Channel locks on the outside edge gently applied.

Excellent - I was just trying to figure out how to remove the ignition switch on my 56, which as the same two grooves. This info came right in time.

Gustave

Nov 25, 2009 | 04:06 PM

tompmatthews

Thread Starter

New User

Joined: Nov 2009

Posts: 14

Likes: 0

From: Reno, NV

Quote:

Originally Posted by fking1

Needle nosed pliers or use a screw driver in one groove and bump the driver.
Channel locks on the outside edge gently applied.

Thanks much! I'll try not to damage the bezels.

Nov 25, 2009 | 08:30 PM

Julies Cool F1

Post Fiend

Joined: May 2008

Posts: 7,641

Likes: 21

From: Poway, Ca.

As mentioned, you can use a small pair of needle nose pliars. But there is a special tool that is available in most of the resto parts shops.

Here is the one from C&G Ford Parts:

Name: TOOL-10852%20~WLOGO.jpg
Views: 982
Size: 17.9 KB