hydraulic clutch bleeding
Thread Starter
|
Senior User
Joined: Mar 2009
Posts: 113
Likes: 0
hydraulic clutch bleeding
Brothers, sisters and all fellow motor heads. I have replaced my clutch master cylinder twice in the past month. I cannot seem to get my clutch pedal back. I have tried several methods of bleeding this thing. I cannot seem to get a good strong gush of fluid down at the slave bleeder when I depress the clutch. What am I doing wrong???????At wits end here. I have not been able to run my truck for a month now
Lead Driver
Joined: Nov 2002
Posts: 9,557
Likes: 44
From: Concord, NC
Did you bench bleed the master cylinder before installing? Once it's installed, open the bleeder with the pedal all the way out, push the pedal to the floor, close the bleeder. Repeat this until you get a good stream of fluid, then pump the pedal several times, hold it on the floor, then open and close the bleeder, repeating several times.
Thread
Thread Starter
Forum
Replies
Last Post
fordfinatic
1987 - 1996 F150 & Larger F-Series Trucks
4
Feb 7, 2009 09:04 AM
keyes
1980 - 1986 Bullnose F100, F150 & Larger F-Series Trucks
2
May 7, 2008 08:19 PM
FordPerf300
Clutch, Transmission, Differential, Axle & Transfer Case
3
Oct 2, 2005 01:34 PM
