302 crank needs turned
Thread Starter
|
Posting Guru
Joined: Jun 2002
Posts: 1,146
Likes: 0
From: Colorado
302 crank needs turned
I need to get the crank turned on my project 302. Anyone recommend a good shop to do this? I would prefer one up in the Westminster/Arvada area for convenience, but that isn't an absolute. Also, what kind of price should I expect?
Senior User
Joined: May 2002
Posts: 298
Likes: 0
From: Denver
302 crank needs turned
I used a shop named Dettmer Automotive. They are south, Englewood to be more exact. They did a nice job one every thing done. I had b02 bored .030 over crank ground .010 rods .010 mians. Cam bearings removed new installed. rods reconditioned with new bolts. And pistons placed on rods. The bill was like $350. I think the crank grind was $60.
There # 303-781-2881 ask for Dave
There # 303-781-2881 ask for Dave
Thread Starter
|
Posting Guru
Joined: Jun 2002
Posts: 1,146
Likes: 0
From: Colorado
302 crank needs turned
Thanks for the information! I did check at 2 places out north, one was $95 and the other $98. Kinda sounded a bit high, but it has been many years since I had any machine work done.
Thread Starter
|
Posting Guru
Joined: Jun 2002
Posts: 1,146
Likes: 0
From: Colorado
302 crank needs turned
>Check out Mountainside Engine Exchange in Golden. Top notch
>work for reasonable prices!
I will do that! Thanks for the help. The project has been put on hold for a while due to a shortage of funds.
>work for reasonable prices!
I will do that! Thanks for the help. The project has been put on hold for a while due to a shortage of funds.
Thread
Thread Starter
Forum
Replies
Last Post
Nathan511
Small Block V8 (221, 260, 289, 5.0/302, 5.8/351W)
5
Jan 27, 2017 05:18 PM
snapy64
1967 - 1972 F-100 & Larger F-Series Trucks
3
May 7, 2014 08:27 PM
MBenavdez
Small Block V8 (221, 260, 289, 5.0/302, 5.8/351W)
2
Jul 1, 2004 08:23 AM
