351w pushrod length
Thread Starter
|
New User
Joined: Feb 2004
Posts: 22
Likes: 0
From: nortwest kansas
351w pushrod length
Hey,
Have not been on the forum for awhile, here goes. I own a 1986 F-250 w/351w HO. But due to the heads they put on in 86 the truck is a dog. I recently purchase a 79' 351W block bored .60 over and the crank has been reworked. It also came with connecting rods. I bought online from PAW a set of D-5 performance heads that are 60cc. We are going with an edlebrock performer rv cam and proform roller rockers and flat top pistons. My question is I need to go with hardened puchrods because we are using guideplates. If the valves are now adjustable what lenght of push rod do i need and if someone would have a product number and where i could get them.
Thanks
Have not been on the forum for awhile, here goes. I own a 1986 F-250 w/351w HO. But due to the heads they put on in 86 the truck is a dog. I recently purchase a 79' 351W block bored .60 over and the crank has been reworked. It also came with connecting rods. I bought online from PAW a set of D-5 performance heads that are 60cc. We are going with an edlebrock performer rv cam and proform roller rockers and flat top pistons. My question is I need to go with hardened puchrods because we are using guideplates. If the valves are now adjustable what lenght of push rod do i need and if someone would have a product number and where i could get them.
Thanks
Thread Starter
|
New User
Joined: Feb 2004
Posts: 22
Likes: 0
From: nortwest kansas
guess i stumped everyone. That is ok i found the info i needed in an isky cam catalogue. So instead of edlebrock we will be using an isky cam and their hardened pushrods. Thanks anyway
Thread
Thread Starter
Forum
Replies
Last Post
powerstroker02
Small Block V8 (221, 260, 289, 5.0/302, 5.8/351W)
11
May 11, 2010 09:04 PM
jdhudall
Small Block V8 (221, 260, 289, 5.0/302, 5.8/351W)
4
Apr 22, 2009 10:46 AM
