a/c clutch removal
Thread Starter
|
Freshman User
Joined: Aug 2009
Posts: 49
Likes: 0
a/c clutch removal
Guys, I know i've been asking alot of questions lately, but I have another. I checked the air gap on my a/c clutch as I was instructed to do, it's at .045". I tried to remove the clutch, and have the bolt out, but how do you get the clutch off of the compressor shaft? I don't want to pry on it for fear of breaking it. Is there a special puller I have to have. Geez, this things kicking my butt!
Any help will be greatly appreciated.......again!
Any help will be greatly appreciated.......again!
Senior User
Joined: Jan 2009
Posts: 318
Likes: 3
From: Brampton, On. Can.
The bolt that holds the hub on the shaft is 6mm. The center hole of the hub is threaded 8mm. Use an 8mm bolt and simply thread it into the hub and tighten. It should push the hub off the shaft.
Thread
Thread Starter
Forum
Replies
Last Post
KaeGee
Big Block V8 - 385 Series (6.1/370, 7.0/429, 7.5/460)
1
Feb 26, 2015 09:06 AM
