Mile Marker Hubs Installed
Thread Starter
|
Elder User
Joined: Oct 2007
Posts: 783
Likes: 0
From: Nova Scotia
Mile Marker Hubs Installed
Finally got the hubs and installed them today.... problem is, the transfer case does not want to engage now. I didn't have time to block off the vacuum lines to the hubs, could that be why the transfer case motor won't engage? Is there a signal that the transfer case motor needs from the vacuum system to engage. I had the motor changed out last year but it is possible that it is again not working.
Any help in trying to figure this out would be appreciated. I have the truck booked at the shop that replaced the motor last year to see if it needs replaced under warranty.
Thanx...
Any help in trying to figure this out would be appreciated. I have the truck booked at the shop that replaced the motor last year to see if it needs replaced under warranty.
Thanx...
Cargo Master
Joined: Dec 2007
Posts: 2,822
Likes: 0
From: Minnesota
I don't think the vacuum line would cause a problem, I ran mine a few days after replacing the hubs befor I capped off the lines and it still engaged and dis-engaged int 4X4 like normal. Hopefully someone else can help shed some light on this!
Junior User
Joined: Mar 2008
Posts: 86
Likes: 0
From: Kendallville IN
I was thinking there was some sort of method that the 4x4 light would stay on when in 2wd so and it would tell you if you had a bad switch or motor I'm not sure but I think somone metioned it before on here?? Testing the switch should be easy if you just unclip it at the motor and test it. If there is a problem there just work your way back till you find it if not might be the motor? Good luck!
Thread
Thread Starter
Forum
Replies
Last Post
WatsonR
6.0L Power Stroke Diesel
4
Sep 8, 2014 08:22 PM
