Your license plate rocks!

We need something super-neato like that!

 

I like the idea of a window sticker in place of a bumper sticker.

 

Thanks Pete, your chapter designs look good also

 

Too bad CT requires unobstructed plates front and rear....

 

Andy, I like the window sticker idea too.

 

Jim:

Please describe further what constitutes obstructed?

I have a chrome frame around my back plate with Ford ovals on it.

Iirc, my wife's has one of those dealership frames around it.

 

Actually our window sticker is white lettering not black, lol

 

Those are both "obstructions" under the law.
ANYTHING that obscures ANY part of your plate. (even my PAC shield)
Though I don't know of any LEO that would pull you over for just that, it is a reason if they want to check you out..

 

Black doesn't show up well esp. on tinted windows.

 

I'll pass on the back window sticker for obvious reasons.

 

Dave, what do you carry on the receiver rack?
Or is that just a step?

 

Jim:

Its a step-bumper, though with the 4" lift its quite the step-off

The trailer hitch was scratch built purposely to tuck into the bumper so I would maintain as much departure angle as possible.

Like several other things, its a half finished project, the 7-pin connector wire harness doesn't mate to the chassis, so I have to just do it one of these nicer day.

Aerocell - Trailer Hitches

 

Wow, that's a lot of fussing for a hitch.

Do you intend to have it hot dipped up at Azco?

 

Flame sprayed would be nice.

The tubes are all cross-welded to each other and to the frame.

The two bolts are there only because of some legal requirement.

 

Don't take much for youse guys to get off topic does it, lmao