rocker stud change
Thread Starter
|
Lead Driver
Joined: Mar 2008
Posts: 7,188
Likes: 384
From: Near Los Angeles
rocker stud change
When I took my head in to have the valves changed to over-size valves, the machinist put in 7/16" rocker studs too.
Doesn't that mean I won't be able to use the stock arms?
The only 7/16" arms I see on all the sites are for roller rockers.
A little help would be appreciated.
Doesn't that mean I won't be able to use the stock arms?
The only 7/16" arms I see on all the sites are for roller rockers.
A little help would be appreciated.
Freshman User
Joined: May 2004
Posts: 43
Likes: 0
From: bc
dont worry about that, stock should work, 7/16s studs are usually on 77 and lower, 3/8s non adjustable on 78 and up. when i got my head done it was dont with 3/8 so there was no screwing around. the studs are pressed in too. stock rockers will work. when i first changed mine because they were worn i used my stock rockers.
Thread
Thread Starter
Forum
Replies
Last Post
Boba Fett
Small Block V8 (221, 260, 289, 5.0/302, 5.8/351W)
5
Nov 5, 2014 12:12 AM
Blown 331
Big Block V8 - 385 Series (6.1/370, 7.0/429, 7.5/460)
20
Mar 9, 2006 03:47 PM
haysr
Big Block V8 - 385 Series (6.1/370, 7.0/429, 7.5/460)
1
Mar 23, 2004 11:35 AM
mike460
Big Block V8 - 385 Series (6.1/370, 7.0/429, 7.5/460)
3
May 14, 2001 02:15 AM
