?? on modding ebpv
Thread Starter
|
Senior User
Joined: Jul 2005
Posts: 429
Likes: 0
From: new york
?? on modding ebpv
I posted this in another thread but I figured I'd start a new one. Is it possible to just weld up the hole where the rod goes through,put the end cap in and weld that and take the solenoid out and cap that then weld it? I'm concerned that if I cut the cylinder off and weld it up I won't get enough oil to the turbo.Thoughts??
Post Fiend
Joined: Apr 2004
Posts: 12,835
Likes: 3
From: Silver Lake Dunes, MI
I posted this in another thread but I figured I'd start a new one. Is it possible to just weld up the hole where the rod goes through,put the end cap in and weld that and take the solenoid out and cap that then weld it? I'm concerned that if I cut the cylinder off and weld it up I won't get enough oil to the turbo.Thoughts??
Thread Starter
|
Senior User
Joined: Jul 2005
Posts: 429
Likes: 0
From: new york
So basically cut the barrel off,weld up the oil passages and weld the solenoid hole. Just a little nervous that's all.Thanks a bunch Tim. I was just looking for that pic from the last time you posted it for me.
