ICP mod not working... why??
Thread Starter
|
Freshman User
Joined: Jul 2006
Posts: 37
Likes: 0
ICP mod not working... why??
Hey everyone I have a 97 F250/4x4/auto. I have been readin' about this 10-22k mod for a while and been playing with it myself! However, unlike everyone else I am getting ZERO response! I have tried 10k, 14.7k,15.6k and 20k. I have checked numerous times to make sure I have good connections also. It seems that no matter what I do or what resistors I put inline (coons way) I get nothing at all for a response. No change of idle, no change or performance or anything.
I have tried a few different ICP sensors, one of which is brand new also.
Any suggestions or ideas for something to look at???
Thanks!
I have tried a few different ICP sensors, one of which is brand new also.
Any suggestions or ideas for something to look at???
Thanks!
Lead Driver
Joined: May 2007
Posts: 8,608
Likes: 13
From: Belair md
not all trucks have idle issues, all of the resistors up to 22k in my truck had no effect on idle at all, you should feel some performance difference, its not going to make it a race truck. the largest difference shold be in low end performance to midrange.
what other modifications do you have to the truck?
what other modifications do you have to the truck?
Posting Guru
Joined: Feb 2008
Posts: 1,354
Likes: 0
mine idles a tad higher not anything major. since im runnin the 20k i noticed a little smoke diff. and when i start it cold she romps and shakes with all white smoke like a superstock for bout a min. i noticed low end and cruising the most along with mileage
