pulled my 6speed out today
Thread Starter
|
Mountain Pass
Joined: Feb 2003
Posts: 207
Likes: 2
From: parkersburg usa
pulled my 6speed out today
heres what i have 200 f350 4x4 6speed build date 3 2000. 4 inch exhaust predator programer hutch mod shimmed fpr. cluth was making some bad noised. pulled apart pilot bearing was completely gone. to my suprise it has the dual mass flywheel wich is dead i pulle a whole sandwich baggie full of parts out of the bellhousing. all the springs are out of the flywheel and broke into little pieces it chipped the end of the starter dented the oil pan up a bit but no realy major damage. gonna go with a solid flywheel and suggestions. it has 281k miles and i have no idea on the maintence history. carolina clutch has the luk kit for 600 do i nneed new new flywheel bolts? or pressure plate bolts?
thanks
chris
thanks
chris
Posting Guru
Joined: Jan 2004
Posts: 1,679
Likes: 0
If I remember correctly. . . the new kit should have new bolts in it. When I got my cerametalic clutch. . . I believe it had new bolts. But if not. . . you got it apart. . . I'd get a new set and put them in there with a nice torque wrench
Timmy
Timmy
