transfer case
Thread Starter
|
Junior User
Joined: Sep 2007
Posts: 61
Likes: 0
transfer case
so im finally getting around to resealing this thing and am wondering what i should torque the bolts to? another thing is it ok to run any kind of atf in these t- cases synthetic or not? what are your guys thoughts?
Post Fiend
Joined: Nov 2003
Posts: 21,285
Likes: 16
From: Nutter Fort, WV
The 92 should have a Borg Warner 1356.
It is important to include the year and as much information as possible.
Between 1983 and 1994 there were two different transfer cases used.
My book don't have much on the 1356, 25 to 43 foot pounds is the only case bolt spec I see.
It is important to include the year and as much information as possible.
Between 1983 and 1994 there were two different transfer cases used.
My book don't have much on the 1356, 25 to 43 foot pounds is the only case bolt spec I see.
Thread Starter
|
Junior User
Joined: Sep 2007
Posts: 61
Likes: 0
well i got the thing all sealed up but it is still leaking 
so my next guess is the front output shaft... is it possible to do while the case is in the truck and what is required any special tools? this one looks like a parking lot fix since i am now at school again 
so my next guess is the front output shaft... is it possible to do while the case is in the truck and what is required any special tools? this one looks like a parking lot fix since i am now at school again
Thread
Thread Starter
Forum
Replies
Last Post
nike_z
Clutch, Transmission, Differential, Axle & Transfer Case
3
Mar 26, 2003 03:33 PM
