setting plug gaps after installing an MSD 6A igntion...
Thread Starter
|
Freshman User
Joined: Apr 2000
Posts: 41
Likes: 0
From: Detroit Lakes, MN
setting plug gaps after installing an MSD 6A igntion...
I am gonna put in an MSD 6A ignition along with the MSD TFI Blaster coil in my 96 302. does anyone out there know the compression ratio for the 96 302? Also the factory reccomendation for plug gap is .054" and I know MSD reccomends increasing the gap. Any ideas on a gap that works best with this setup? everything is pretty much stock for now except for a K&N filter.
JP
1996 XLT 302/e4od
JP
1996 XLT 302/e4od
Thread
Thread Starter
Forum
Replies
Last Post
mike460
Big Block V8 - 385 Series (6.1/370, 7.0/429, 7.5/460)
2
Mar 12, 2003 11:55 AM
