t case
Thread Starter
|
Elder User
Joined: Aug 2007
Posts: 782
Likes: 0
From: South Carolina
t case
Hello minions. Its been a while. Had to send my computer off to get charge port re-soldered. I have felt sooo disconnected without it.
Anyhow I have a question. I have a BW 1350 t case out of a Ranger(of course). Is there anyway to make a homemade slip yoke eliminator? It is for the front shaft. I was thinking of machining the shaft behind the case to accept a snap ring or installing some kind of lock/retainer bearing on the front shaft. Thanks in advance.
Anyhow I have a question. I have a BW 1350 t case out of a Ranger(of course). Is there anyway to make a homemade slip yoke eliminator? It is for the front shaft. I was thinking of machining the shaft behind the case to accept a snap ring or installing some kind of lock/retainer bearing on the front shaft. Thanks in advance.
just another Rockwell looser
Joined: Feb 2003
Posts: 4,042
Likes: 0
From: Cocoa, FL
yes, anything is possible........but prob. not worth the cost....
Thread
Thread Starter
Forum
Replies
Last Post
Tim Young
1994.5 - 1997 7.3L Power Stroke Diesel
14
Jun 15, 2025 09:55 PM
jlaudio_f100
1973 - 1979 F-100 & Larger F-Series Trucks
8
Feb 28, 2010 06:01 PM
jd_boggs
Clutch, Transmission, Differential, Axle & Transfer Case
2
Jul 13, 2006 07:57 AM
chrono4
Clutch, Transmission, Differential, Axle & Transfer Case
6
Jul 8, 2005 02:06 PM
