another edge problem question
Thread Starter
|
Hotshot
Joined: Jun 2007
Posts: 10,008
Likes: 7
From: Austin, TX
another edge problem question
last night i plugged my edge in to record a quarter mile time. it kept aborting the runs and then when i tried to read the codes it kept bringing up codes that don't exist. when i tried to clear them it said unable to clear codes. and when i tried to go into the data stream it would only show up with the engine rpm's but not the EOT, line pressure, exhaust back pressure, or any of that stuff. i'm probably going to call edge about it, but maybe y'all can help me figure the problem out. what do y'all think?
Post Fiend
Joined: Oct 2003
Posts: 5,903
Likes: 1
From: MICHIGAN
Not sure if this pertains but my buddy has Edge Juice w/Attitude...had nothing but trouble with it. Appearantly the screen doesn't like extreme cold temps, it's just black until the cab warms up. It continuously looses it's programming. And Oh Ya, the drag race mode is very touchy, the accelerometer (drag race mode) shifts off too easy. It thinks you are decelerating when the truck hits a bump...even under hard acceleration.
They have a great service dept tho. Very nice on the phone and quick to respond. They send the replacement parts to him even before the old part has reached them.
They have a great service dept tho. Very nice on the phone and quick to respond. They send the replacement parts to him even before the old part has reached them.
Thread
Thread Starter
Forum
Replies
Last Post
racenitro
1994.5 - 1997 7.3L Power Stroke Diesel
7
Jul 28, 2014 04:14 PM
