intake plenum boots

Reply Subscribe

Thread Tools

Search this Thread

Feb 2, 2008 | 10:03 AM

mndiesel

Thread Starter

Postmaster

Joined: Jan 2007

Posts: 3,418

Likes: 1

From: Circle Pines

intake plenum boots

What is the best way to get replace the boots in the valley? Thanks

Feb 2, 2008 | 10:13 AM

clux

Post Fiend

Joined: Feb 2002

Posts: 10,600

Likes: 3

From: Carhenge

You just have to remove the intake spider. There's a variety of vendors who offer replacements.

Feb 2, 2008 | 10:37 AM

mndiesel

Thread Starter

Postmaster

Joined: Jan 2007

Posts: 3,418

Likes: 1

From: Circle Pines

I already have dieselsites boots I was just trying to see if there was an asy way to get the spider off

Feb 2, 2008 | 10:43 AM

Izzy351

Post Fiend

Joined: Feb 2007

Posts: 14,541

Likes: 2

From: Dallas-Ft. Worth

Disconnect electrical connections, wastegate control lines, MAP sensor line, and loosen the clamps. Comes right out.

Feb 2, 2008 | 10:46 AM

mndiesel

Thread Starter

Postmaster

Joined: Jan 2007

Posts: 3,418

Likes: 1

From: Circle Pines

Quote:

Originally Posted by Izzy351

Disconnect electrical connections, wastegate control lines, MAP sensor line, and loosen the clamps. Comes right out.

Thanks that is just what I was looking for. Rep points awarded

Feb 2, 2008 | 11:08 AM

Izzy351

Post Fiend

Joined: Feb 2007

Posts: 14,541

Likes: 2

From: Dallas-Ft. Worth

NP -- thanks for the reps. Just be careful not to drop anything down the open plenums. There is a screen in there, but something small enough could drop through. It's a good idea to keep a rag stuffed in them if you'll have the spider off for any amount of time.