Which boots do you need to swap the stock 6.0 IC? I already have this one: www.puredieselpower.com/catalog/intercooler-tube-connection-transition-hose-325-p-503.html. Is this the only one I need, or is there another transition hose I need on the other side? Thanks for the help, Nick

 

Try this, I bookmarked it when I was gathering info on this mod. I never did it bc the 6.0 ic's have been going too high for my cheap AAAAAAs.

https://www.ford-trucks.com/articles...oke/Page1.html

 

That one will fit the passenger's side, but you need a 3 x 3 x 8 and one 3" boot clamp for the driver's side. The inlet for the 6.0L I/C is smaller than the 7.3L one.

 

How much of a bigger IC is this and it fits with out hiting anthing right,
Nick

 

It's slightly thicker and definately taller. Is your truck a 6 speed or an auto? If it's an auto, you need to upgrade the transmission cooler to a 6.0L unit or relocate the stock one. Otherwise the new I/C will hit the trans lines on the passenger's side corner and you'll have a heck of a time getting it in.