Best intake that matches 351M heads?
#1
Best intake that matches 351M heads?
A buddy of mine has an old Edelbrock 400 - SP2-P intake. The intake ports are much smaller than the head ports.
The head part number is stock (I think), part number: D5AEA-2-A.
What is a good beneficial intake to match the flow potential of the 351M heads?
The head part number is stock (I think), part number: D5AEA-2-A.
What is a good beneficial intake to match the flow potential of the 351M heads?
#4
It is the only one E-brock makes (currently) for the 351M.
The SP2P is of interest to people looking to go to EFI. If I remember correctly. Small runners are good for low-end torque and mpg.
There is a Holly Dominator 4-barrel manifold on e-bay for the 351M. Also good for EFI. http://cgi.ebay.com/ebaymotors/Ford-...QQcmdZViewItem
The SP2P is of interest to people looking to go to EFI. If I remember correctly. Small runners are good for low-end torque and mpg.
There is a Holly Dominator 4-barrel manifold on e-bay for the 351M. Also good for EFI. http://cgi.ebay.com/ebaymotors/Ford-...QQcmdZViewItem
Thread
Thread Starter
Forum
Replies
Last Post
Order and Chaos
FE & FT Big Block V8 (332, 352, 360, 390, 406, 410, 427, 428)
15
05-18-2016 07:56 AM
kilich
FE & FT Big Block V8 (332, 352, 360, 390, 406, 410, 427, 428)
2
11-27-2011 08:54 PM
73 ford guy
FE & FT Big Block V8 (332, 352, 360, 390, 406, 410, 427, 428)
19
11-22-2010 06:28 PM
jamies460
Big Block V8 - 385 Series (6.1/370, 7.0/429, 7.5/460)
6
05-12-2008 09:41 AM