I have a 98 Ford Windstar. I exchanged a right side spindle with one I picked up from the junk yard. Now I have my ABS light on and the Trac Off light flashing. Can the ABS sensor be removed from the spindle and replaced with the one in the spindle I took off? How do I remove it if so?

 

You should see the sensor at the spindle. It should have a small bolt head, about an 8mm or so. Remove the bolt, probably have to wiggle it side to side a few times to free it up and get it out. Fallow the wire back and un-plug.

Bob

 

I Have The Same Problem I Replaced The Pass Side Hub And Now My A B S Light Comes On Did You Ever Get It Figured Out Thanks John

 

I haven't really had time to mess with it. This is the 3rd time I replaced the hub and spindle but the 1st time I had a problem with the ABS sensor.