Will I need anything else?
Thread Starter
|
New User
Joined: Jul 2007
Posts: 18
Likes: 0
Will I need anything else?
I'm trying to finish up the rebuild on my truck and I was wondering how it will react to what I have going here. It's a 89' F-250 351 with HD 5 speed, 3.55's. I installed the Crane Cams 444232 grind cam in (int.448-exh.464), fully rebuilt E7 heads are going on and they are ported under the valves, I also am putting on long tubes with a custom dual exhaust system exiting before the rear tires. Just want to know if I should do anything or will this be much better than before? It was so bad before, just burning oil and couldn't barely pull itself, leaking all over. New custom speed pro rings, new bearing and seals should have taken care of most of that power loss and oil consumption. Is this setup ok or what should I expect to come?
Thread Starter
|
New User
Joined: Jul 2007
Posts: 18
Likes: 0
An X-pipe will not do anything for me. But yeah Conanski I hope for the best, I haven't seen this truck run normal so hopefully it's twice the gain.
To me it is. Thanks for the gas tip, I'm sure prices will go up by the time I have it running, isn't that how it goes?..
Alright so this is good then I hope.
To me it is. Thanks for the gas tip, I'm sure prices will go up by the time I have it running, isn't that how it goes?..
Alright so this is good then I hope.
Thread
Thread Starter
Forum
Replies
Last Post
green 69
1999 - 2003 7.3L Power Stroke Diesel
5
Feb 23, 2012 01:11 PM
TheMechanicalAnimal
Small Block V8 (221, 260, 289, 5.0/302, 5.8/351W)
2
Mar 29, 2009 04:42 PM
speed
Big Block V8 - 385 Series (6.1/370, 7.0/429, 7.5/460)
15
May 14, 2005 12:31 PM
