428 to replace 400
Thread Starter
|
Posting Guru
Joined: Jan 2005
Posts: 1,299
Likes: 2
From: The Vieux Ford, Kansas
428 to replace 400
I have a 79 F250 4x4 with a 400 and i also have a 428 off an irrigator that runs great i want to put in the truck. I know i will need a bellhousing and i already have a flywheel, can i use motormnounts and perches out of a 76 or earlier truck that has an FE motor and does my Warner T-18 have the right imput shaft or do I also need a tranny out of an FE powred truck. thanks
-johnboy
-johnboy
I'll have the Roast Duck
Joined: Jul 2002
Posts: 9,622
Likes: 110
From: Northshore, MN
being an implement engine, it may have a different pilot bushing, but I see no problems. Sound like yer on the right track, maybe need new exhaust and a radiator to boot. Maybe a throttle cable for an FE, also. The perches will need to be from an FE, but you might need to drill a couple holes. the tranny should work, but just make sure the end fits the bushing. Good luck
PS:I seen a dump truck w/428 and thought the same thing. but make sure it's an FE, cuz it might be an FT.
PS:I seen a dump truck w/428 and thought the same thing. but make sure it's an FE, cuz it might be an FT.
Thread Starter
|
Posting Guru
Joined: Jan 2005
Posts: 1,299
Likes: 2
From: The Vieux Ford, Kansas
Thanks for the help, the motor is an FE not an FT and it ran great a kid down in baldwin put it in his truck and promptly lost his licences i traded his dad a toploader 4sd for it he drove the truck to our place and we pulled it, its a runner with all the good stuff mirror 105 ribbed and cross bolted block with screw in freeze plugs a 1UA Super CJ crank and a cool old eddy tripower with strombergs to boot. The heads are some openchambred D2 castings think i will run my C3AE-G low risers.
-johnboy
-johnboy
Thread
Thread Starter
Forum
Replies
Last Post
johnboy427
FE & FT Big Block V8 (332, 352, 360, 390, 406, 410, 427, 428)
13
Feb 9, 2010 05:51 AM
johnboy427
1973 - 1979 F-100 & Larger F-Series Trucks
1
May 24, 2008 03:28 AM
