kick down issues after floor shifter install.
Thread Starter
|
Posting Guru
Joined: Nov 2005
Posts: 1,113
Likes: 0
From: the side of a mountain
kick down issues after floor shifter install.
i just installed a B&M floor shifter and now my kick down lever wont move. is it becuase the bracket that clamps over the old shifter linkage is pinching something? also does anyone know the thread pitch on the rod for the kick down linkage? this is on a C6 tranny.
Thread Starter
|
Posting Guru
Joined: Nov 2005
Posts: 1,113
Likes: 0
From: the side of a mountain
ignore every thing i said, i found the right nut and the rod in the tranny had gotten pushed in and when i tightend down the kick down linkage it pulled it out and it works fine now.
Thread
Thread Starter
Forum
Replies
Last Post
Kirbys73F100
1973 - 1979 F-100 & Larger F-Series Trucks
31
Nov 27, 2011 03:08 PM
oldcoupe42
Clutch, Transmission, Differential, Axle & Transfer Case
4
Jun 22, 2009 03:27 PM
FRIENDSF150
Clutch, Transmission, Differential, Axle & Transfer Case
1
Aug 4, 2005 06:27 PM
JoeBlow
Clutch, Transmission, Differential, Axle & Transfer Case
2
Nov 2, 2003 11:51 PM
