Programming 94 Explorer Keyless Remote

Reply Subscribe

Thread Tools

Search this Thread

Mar 29, 2006 | 03:50 PM

Repsher

Thread Starter

Freshman User

Joined: Dec 2003

Posts: 30

Likes: 0

Programming 94 Explorer Keyless Remote

I lost my remote a few years ago and finally just bought a new one, however I can't program it to work. It seems from 95 and later you go through a cycle of on offs with the keys but the 94 is different,"Turn ignition to RUN or ACC. Momentarily jump pins in programming connector located in left rear quarter panel area. All doors will lock then unlock to confirm programming mode. Press any button on 1st transmitter. Door locks will lock then unlock to confirm programming." I found this article but where is this pin at? in the engine compartment or under the steering wheel? I don't know what I'm looking for please help me.
mike

Mar 29, 2006 | 04:01 PM

ledbetter

Senior User

Joined: Dec 1999

Posts: 178

Likes: 0

From: Pcola, FL

Left rear quarter panel should be the interior, probably in the cargo area...

Last edited by ledbetter; Mar 29, 2006 at 04:03 PM.

Mar 29, 2006 | 06:00 PM

Repsher

Thread Starter

Freshman User

Joined: Dec 2003

Posts: 30

Likes: 0

Alright I just went to the back where the panel was and started shorting everything I could see, after about 4 tries I found the right one and was able to program the remote. So everything works now, thanks
mike