View Poll Results: TMI Super Cleveland Torque and Hp Guess Poll
300 - 350 T 250 - 300Hp
0
0%
350 - 400T 250 - 300HP
0
0%
400 - 450T 300 - 350HP
0
0%
Multiple Choice Poll. Voters: 21. You may not vote on this poll
TMI 434 Stroker Pre-Poll
Laughing Gas
Joined: Nov 2002
Posts: 1,198
Likes: 9
From: Fairmont
danlee and cwheel,
Is that all you think??
The project engine we did made 465 torque and 390 hp.
Is that all you think??
The project engine we did made 465 torque and 390 hp.
Trending Topics
Postmaster
Joined: Aug 2001
Posts: 4,270
Likes: 5
From: Delaware
FTE Stories
Ford Trucks for Ford Truck Enthusiasts
Top 6 Best Deals Available on New Fords & Lincolns Right Now
Brett Foote
This Hennessey Takes the Expedition Tremor's Off-Roading Capability to the Next Level
Verdad Gallardo
Top 10 Fords at 2026 Carlisle Ford Nationals
Joe Kucinski
3 Best / 3 Worst Parts of Modern Ford Ownership
Brett Foote
10 Amazing Upgrades That Solve Common Ford Truck Owner Headaches
Pouria Savadkouei
Every 2026 Ford Engine Explained
Brett Foote
10 Ugly Ford Trucks That We Still Kinda Love
Joe Kucinski
10 Things Every Truck Owner NEEDS (2026 Edition)
Michael S. Palmer
Rezvani's Latest Post-Apocalyptic Monster Is a Ford F-150 Raptor Underneath
Verdad Gallardo
Thread Starter
|
Junior User
Joined: Feb 2006
Posts: 86
Likes: 0
Danlee,
I have ran a bunch of dyno sims on this engine set up on Dyno2000 software that a buddy has. Be sure to put in the open headers because that is how it will be dyno'd. When I tried this setup, though with a slightly differnet cam (smaller lift) We had over 500hp and over 600 torque. Also single plane intake, flow chart from CHI's website with valve sizes listed on the website and I think we used an (800 CMF(I think)) carb.
I can't wait to see the outcome of the real thing!!!!!!
I have ran a bunch of dyno sims on this engine set up on Dyno2000 software that a buddy has. Be sure to put in the open headers because that is how it will be dyno'd. When I tried this setup, though with a slightly differnet cam (smaller lift) We had over 500hp and over 600 torque. Also single plane intake, flow chart from CHI's website with valve sizes listed on the website and I think we used an (800 CMF(I think)) carb.
I can't wait to see the outcome of the real thing!!!!!!
Senior User
Joined: Feb 2006
Posts: 212
Likes: 0
I erred on the high side in my vote. What the heck..we can wish and hope Mr. Tim is going to pull a real rabbit out of that hat.
Yes Dan..this engine is certainly targeted toward a different goal than the BD project motor..as you have already figured out. Maybe we can build one like this one too..8-)
Yes Dan..this engine is certainly targeted toward a different goal than the BD project motor..as you have already figured out. Maybe we can build one like this one too..8-)