Brake Upgrades
Thread Starter
|
New User
Joined: Feb 2005
Posts: 17
Likes: 0
Brake Upgrades
Well I have tried searching all the threads for upgrades for my 05 F-250 PSD brake systems with no luck. I was wondering if any of my fellow members have had any experience with the category or if you can point me in the right direction. Any help would be greatly apprecitated.
Thanks in advance
-David
Thanks in advance
-David
Former Vendor
Joined: Mar 2004
Posts: 4,362
Likes: 3
From: Hendersonville, NC
http://www.brake-pros.com/brakepros_...d=40933&page=2
This is fro an 04, but they may have an 05 kit out ready for release- I'd give them a call.
I have that set on the front of my truck, with thier matching 4-piston set on the rear. With those 2-piece rotors, you can also have the rotor removed, turned, and laid with carbon for carbon pads...and they stop stupid fast.
A good updgrade is to also find the master cylinder from a 2005/2006 F550.
This is fro an 04, but they may have an 05 kit out ready for release- I'd give them a call.
I have that set on the front of my truck, with thier matching 4-piston set on the rear. With those 2-piece rotors, you can also have the rotor removed, turned, and laid with carbon for carbon pads...and they stop stupid fast.
A good updgrade is to also find the master cylinder from a 2005/2006 F550.
Senior User
Joined: Jul 2004
Posts: 375
Likes: 0
From: W. Philly Burbs
Hey PSD 60L, is the master cylinder just a larger one for the 05/06 550s? and is it basically just a "bolt on" mod? Ive replaced them before, just never replaced one with a different one haha.
Thread Starter
|
New User
Joined: Feb 2005
Posts: 17
Likes: 0
PSD: Thanks for the Link and quick response 
Now I have to ask which set up you have? I have run AP products on some of my past cars and I loved them, but I don't know if I need something that extreme for the truck. I ran a set of there 6 pot calipers and 14" rotors on my old WRX, but then again that was a autocross car and set-up. Though it was my daily driver but shhhh nobody knew that 
-David
Now I have to ask which set up you have? I have run AP products on some of my past cars and I loved them, but I don't know if I need something that extreme for the truck. I ran a set of there 6 pot calipers and 14" rotors on my old WRX, but then again that was a autocross car and set-up. Though it was my daily driver but shhhh nobody knew that -David
Thread
Thread Starter
Forum
Replies
Last Post
jd111404
1997 - 2006 Expedition & Navigator
7
Apr 21, 2007 12:25 PM
masonma
1987 - 1996 F150 & Larger F-Series Trucks
5
Apr 7, 2006 01:46 PM
