Exhaust
Thread Starter
|
Freshman User
Joined: Oct 2004
Posts: 27
Likes: 0
Exhaust
I have a 94 5.0. I was wondering if it is possible to cut the cats off the factory Y pipe and weld on two high flow cats? Can they heater tube run off of one cat or does it need to draw from both cats? Is there anyone that makes a dual in/ dual out 2 1/4" cat? The biggest cat I can find like that is 2".
Thanks in advance for any help
Thanks in advance for any help
Lead Driver
Joined: Sep 2002
Posts: 9,182
Likes: 12
From: Gateway to the West
Search this forum. The amount of info is overwhelming. The most commonly mentioned/sought after/preferred, exhaust component is the Bassani Y-pipe which comes with an available high-flow cat. 3" IN and 3" OUT single exhaust which will perform better than duals. The "heater tube" is the air injection tube from the smog pump to the catalytic converter and the Bassani unit reuses it.
Senior User
Joined: Aug 2004
Posts: 173
Likes: 0
found a dual 2" dual 2-1/2 reversible:
http://www.xtremeflow.com/catalyticconverters.htm
scroll down a ways to find it
http://www.xtremeflow.com/catalyticconverters.htm
scroll down a ways to find it
Thread
Thread Starter
Forum
Replies
Last Post
