Project update...
Thread Starter
|
Posting Guru
Joined: Jul 2003
Posts: 1,268
Likes: 0
From: Eureka, Ca.
Project update...
I been stocking up on parts the last few monthes. Here is what i have so far:
Detroit lockers front and rear
5.13:1 gears
1410yokes for the axles and the front output on my NP205
1350 yokes for the trans and input of the NP205 and a 1350 CV yoke for the rear output.
46" Baja Claws mounted on M/T Classic II rims
I Fabbed up a rear mount radiator setup
I still need to fab a crossmember for the NP205. Any ideas?
Once the NP 205 is mounted I will be getting driveshafts from Jess at HiAngle.
I will be updating my website soon I will post the link when it is done.`
Detroit lockers front and rear
5.13:1 gears
1410yokes for the axles and the front output on my NP205
1350 yokes for the trans and input of the NP205 and a 1350 CV yoke for the rear output.
46" Baja Claws mounted on M/T Classic II rims
I Fabbed up a rear mount radiator setup
I still need to fab a crossmember for the NP205. Any ideas?
Once the NP 205 is mounted I will be getting driveshafts from Jess at HiAngle.
I will be updating my website soon I will post the link when it is done.`
Thread
Thread Starter
Forum
Replies
Last Post
Greg5OH
1987 - 1996 F150 & Larger F-Series Trucks
6
Aug 20, 2014 09:42 AM
RCook527
Clutch, Transmission, Differential, Axle & Transfer Case
7
Feb 3, 2006 12:52 AM
