Pond 427 Sideoiler Blocks???
Thread Starter
|
Elder User
Joined: Nov 2003
Posts: 936
Likes: 0
Pond 427 Sideoiler Blocks???
I think FFR428 mentioned something about these and that they are a little more on the side of sanity than the Genesis 427 Iron blocks. Does this company have a website?
Needsmorecoffee.
Joined: Oct 2004
Posts: 3,624
Likes: 2
From: CT
The unmachined iron blocks are selling for $3000 and I'm pretty sure Keith Craft was selling them machined ready to go for $3500. Check out www.fordfe.com Robert Pond was on there a month or so ago chatting about them. Maybe look up the thread and shoot him an email. He was very nice and responded to eveyone's questions. A few guys over at Club Cobra are running his blocks and Keith built the engines. Two aluminum and one iron I've seen so far. So they are out there. I kind of hoped they would be $3000 ready to go but guess not. G.
Needsmorecoffee.
Joined: Oct 2004
Posts: 3,624
Likes: 2
From: CT
Nope the Genesis blocks are the same deal and you need to get them machined. They run around $500 more than the Pond blocks. You know I have a funny feeling about these two blocks. Both castings look VERY similar to each other but supposedly they are two different companies. I'm wondering if some note sharing was done...and maybe the casting molds also. G.
Thread
Thread Starter
Forum
Replies
Last Post
carpenter547
FE & FT Big Block V8 (332, 352, 360, 390, 406, 410, 427, 428)
5
Jul 16, 2010 07:28 PM
blacktail427
FE & FT Big Block V8 (332, 352, 360, 390, 406, 410, 427, 428)
4
Jan 15, 2004 11:19 AM
FEina52F1
FE & FT Big Block V8 (332, 352, 360, 390, 406, 410, 427, 428)
7
Jun 6, 2002 05:42 AM
