BBK Throttle Body for 02 F250
Thread Starter
|
New User
Joined: Sep 2004
Posts: 11
Likes: 0
BBK Throttle Body for 02 F250
Hey Guys, Anyone have any info if putting a BBK 75mm throttle body on my 5.4L 02 F-250 would do any good. What is the stock mm?
Last edited by JavaJoe; Sep 16, 2004 at 07:46 PM.
Elder User
Joined: Dec 2003
Posts: 807
Likes: 1
From: Idaho
Does the stock throttle body have just one opening? On my v-10 it's a twin valve. I went from stock to 62mm. I have a cold air intake, larger MAFS, throttle body, headers, flowmaster. Just the body may not do all that much.
Thread Starter
|
New User
Joined: Sep 2004
Posts: 11
Likes: 0
Yeh, it has one opening. I found out it is a 68mm and my new one is a 75mm. I just put it in yesterday. It took about 20 minutes. I had to deprogram my computer. Then reprogram after installing it. I already have a Flowmaster cat-back with Gibson headers, superchip programmer,throttle body spacer, cold air intake and now a bigger throttle body. I think it added some power and it sounds throatier with no whistle. I think it was a good choice. What's the deal with a larger MASF?
Thread
Thread Starter
Forum
Replies
Last Post
t_chapps
Small Block V8 (221, 260, 289, 5.0/302, 5.8/351W)
1
May 30, 2006 09:56 PM
