Headers/Manufacturers/v10
Thread Starter
|
New User
Joined: Jul 2000
Posts: 15
Likes: 0
Headers/Manufacturers/v10
Has anyone done any reasearch on the hp increases/ tubing gauge/ flange thickness. Has anyone heard of Mesa Headers, my fatherinlaw has some and they are the best set of headers I has seen in a long time. I believe they starting to make some for the v10.
Logistics Pro
Joined: Feb 2000
Posts: 3,955
Likes: 50
From: Mesa
Headers/Manufacturers/v10
As of right now, I think Borla and Banks are the only companys making headers. I don't know the exact specs of each but the HP/TQ numbers look good. A complete Banks kit, called the Power Pack includes a K&N type air filter, a new larger air box, headers, crossover pipe and cat-back exhaust system. It will set you back $1500. You can get the parts seperate from Banks also. Borla sells their products seperately. The Borla headers put out 30hp, 35tq. Their cat-back systems add 20hp, 25tq. So, in total, Borla is close to the Banks #'s. A complete Borla setup would run about $950.
Thread Starter
|
New User
Joined: Jul 2000
Posts: 15
Likes: 0
Headers/Manufacturers/v10
Hey V-10Man have you looked up Mesaheaders.com. Im not sure if they have come through with the headers yet, but the headers that I have seen them produce are pretty sweet. Take a look at the sight and tell me what ya think!
Senior User
Joined: Jun 1999
Posts: 201
Likes: 1
Headers/Manufacturers/v10
I installed the Banks PowerPack, I havn't been back to the dyno yet though.
The flange on these is 1/2" Stainless Steel. Check out some of my problems envountered when Banks sent a 1999 kit for my 2000 truck at: http://ic.net/~wawii/banks/
------------------
Thanks,
Will
2000 F-250 SD Crew Cab, Short Bed, Lariat, 4X2, V-10, Auto, 3.73LS
The flange on these is 1/2" Stainless Steel. Check out some of my problems envountered when Banks sent a 1999 kit for my 2000 truck at: http://ic.net/~wawii/banks/
------------------
Thanks,
Will
2000 F-250 SD Crew Cab, Short Bed, Lariat, 4X2, V-10, Auto, 3.73LS
New User
Joined: Jul 2000
Posts: 24
Likes: 0
Headers/Manufacturers/v10
As far as i know Mesa Headers is on the verge of putting put the V-10 headers. They look to be real quality. 1/2" flange and the best thing no gasket.
Good company with good customer service. Give them a call they'll tell you about the expected date.
Also I spoke with JBA in San Diego, They are coming out with the headers for the V-10 this month some time, or so they say. As far as Ford goes JBA seems to know their stuff.
Price for the MEsa Headers is gonna be around 650.00
I think I'll pay that before I go out and pay 1016.00 for the BANK'S
I'm not sure about JBA'S.
Good company with good customer service. Give them a call they'll tell you about the expected date.
Also I spoke with JBA in San Diego, They are coming out with the headers for the V-10 this month some time, or so they say. As far as Ford goes JBA seems to know their stuff.
Price for the MEsa Headers is gonna be around 650.00
I think I'll pay that before I go out and pay 1016.00 for the BANK'S
I'm not sure about JBA'S.
Thread
Thread Starter
Forum
Replies
Last Post
