performer cam+chip??
Thread Starter
|
Tuned
Joined: Aug 2003
Posts: 386
Likes: 28
From: Garnett, KS
performer cam+chip??
I didn't get much response on this (actually none) in the 80-86 forum, so I'll try here...
I'm doing a driveline swap (302, 4x4, probably inducion system from 86 Bronco), and am getting ready to rebuild the motor. I'm planning on putting a Edelbrock performer cam (idle-5,500) in it. The 87 that's receiving all the stuff, is fuel injected too (obviously), but the induction stuff is scattered about and prolly incomplete.
So my questions are:
1)Is there a chip available for the 86 computer?
2)How about the 87?
3)Should I just scrap the idea, throw a carb at it (mighthappenanyways), and quit screwin around?
Frank
I'm doing a driveline swap (302, 4x4, probably inducion system from 86 Bronco), and am getting ready to rebuild the motor. I'm planning on putting a Edelbrock performer cam (idle-5,500) in it. The 87 that's receiving all the stuff, is fuel injected too (obviously), but the induction stuff is scattered about and prolly incomplete.
So my questions are:
1)Is there a chip available for the 86 computer?
2)How about the 87?
3)Should I just scrap the idea, throw a carb at it (mighthappenanyways), and quit screwin around?
Frank
Post Fiend
Joined: Jan 1997
Posts: 23,165
Likes: 18
From: Enjoying the real world.
It the odds of chipping an 86 are low, it depends on the PCM code. If you can get that from the white sticker on the computer box I'll let you know. The odds for 87 are better but it still depends on the code. 
I'll try like hell to get the code this weekend 
Thread
Thread Starter
Forum
Replies
Last Post
dodgemike
1980 - 1986 Bullnose F100, F150 & Larger F-Series Trucks
2
Jan 24, 2013 09:50 AM
87stxranger
1980 - 1986 Bullnose F100, F150 & Larger F-Series Trucks
3
Jul 11, 2002 10:34 PM
