oil pressure sensor location?
Postmaster
Joined: Nov 2001
Posts: 4,742
Likes: 8
From: OK
oil pressure sensor location?
>some are on the right side of the engine by the fuel pump on
>a aluminum extension and some are on the back behind the
>carberator by the trani housing
Ahhh the "really old" days when fuel pumps were on the engine and fed big 4BBL carbs!
To dream.....
>a aluminum extension and some are on the back behind the
>carberator by the trani housing
Ahhh the "really old" days when fuel pumps were on the engine and fed big 4BBL carbs!
To dream.....
Post Fiend
Joined: Jan 2002
Posts: 5,859
Likes: 7
From: USA
oil pressure sensor location?
Yea! the days of Sunoco 260 in my Boss 429 Mustang!
I couldn't pass a gas station with out stoppin for petrol!
yea them's was the days!
Oh thanks Nomo I needed that!
Now back to today
Yeti and I are waitin for someone to tell us where the sender is on the 5.4 in the duty's I think its up near the intake plenum!
I'm too lazy to to look anymore.
Later
Rich
Ford Trucks Built Tough!
not with rocks
Watch out "X" Mayor of Truckville
I couldn't pass a gas station with out stoppin for petrol!
yea them's was the days!
Oh thanks Nomo I needed that!
Now back to today
Yeti and I are waitin for someone to tell us where the sender is on the 5.4 in the duty's I think its up near the intake plenum!
I'm too lazy to to look anymore.
Later
Rich
Ford Trucks Built Tough!
not with rocks
Watch out "X" Mayor of Truckville
Sit. Stay.
Joined: Oct 2001
Posts: 18,308
Likes: 20
From: Washington State
oil pressure sensor location?
>Now back to today
>Yeti and I are waitin for someone to tell us where the
>sender is on the 5.4 in the duty's I think its up near the
>intake plenum!
Same place as the V10, right??
>Yeti and I are waitin for someone to tell us where the
>sender is on the 5.4 in the duty's I think its up near the
>intake plenum!
Same place as the V10, right??
Postmaster
Joined: Nov 2001
Posts: 4,742
Likes: 8
From: OK
oil pressure sensor location?
According to the F150 guys, it seems the sending unit could be in one of two places...
Just below the exhaust manifold or right at the oil filter location. There is only 1 wire running to it, so it may not "look" like a sending unit that you are used to seeing.
Just below the exhaust manifold or right at the oil filter location. There is only 1 wire running to it, so it may not "look" like a sending unit that you are used to seeing.
Thread
Thread Starter
Forum
Replies
Last Post
fordopie
Explorer, Sport Trac, Mountaineer & Aviator
13
Feb 27, 2018 09:03 PM
tylerbush
FE & FT Big Block V8 (332, 352, 360, 390, 406, 410, 427, 428)
8
Sep 26, 2013 05:25 AM
djmac
Big Block V8 - 385 Series (6.1/370, 7.0/429, 7.5/460)
4
May 13, 2004 05:16 PM
