c6 transmission
Thread Starter
|
1st Gear
Joined: May 2026
Posts: 1
Likes: 0
c6 transmission
I have a c6 behind my 351c and watching a video here about replacing servo to an R servo ,do I have to do any internal trans work or can I just pull old one out and put the new one in ? Thanks
Cargo Master
Joined: Oct 2020
Posts: 2,710
Likes: 801
I think that the R servo is only compatible with certain levers. Read up on that because I think that if you have the wrong combination it can break the band or cause some weird shift timing problems. Shift timing problems are the #1 killer on a C6.
Cargo Master
Joined: Feb 2004
Posts: 2,085
Likes: 176
From: Central Texas
I'll have to admit I do not know what an R servo does, but I am curious as to why you think this is necessary? When I rebuilt my the C6 for my '65 I added a Transco shift kit that allows full manual control if you want, otherwise it works normally. It also had 3 levels of shift firmness I believe; I went for the firmest. That might have been a little too aggressive but 30 years later the thing still works great and will bark the tires at both shifts. As far as I know the internals are all original but for the wear items in the rebuild kit....and the shift kit.
Thread
Thread Starter
Forum
Replies
Last Post
elemint
Clutch, Transmission, Differential, Axle & Transfer Case
1
Oct 10, 2004 04:25 PM
duece-bigalo01
Clutch, Transmission, Differential, Axle & Transfer Case
5
Apr 25, 2004 01:38 AM
unioncreek
Clutch, Transmission, Differential, Axle & Transfer Case
5
Nov 11, 2001 11:45 PM
