clutch compatibility
Thread Starter
|
Cross-Country
Joined: Mar 2015
Posts: 73
Likes: 3
clutch compatibility
I bought a 300 inline 6 but not 100% sure of what it came out of. I need to replace the 10" clutch that came with it. Are all 10" clutches / pressure plates for the ford 300 interchangeable?
Thanks
Thanks
Last edited by glen_melton; May 21, 2024 at 04:13 PM. Reason: clarification
Lead Driver
Joined: Sep 2003
Posts: 7,010
Likes: 203
From: SoCal
I looked in RockAuto's catalogs for the clutch kits for the engine of various years. Apparently there was a change between 1982 and 1983 in the pressure plate. I have no idea what it is, or what are the differences, but every manufacturer list different parts for those years.
Thread Starter
|
Cross-Country
Joined: Mar 2015
Posts: 73
Likes: 3
After going through many posts I think Ill be ok with using the flywheel from the engine im replacing, I know that a 1979 11" will bolt to it. It seems the only difference though the years for the 300 flywheels are the pressure plate bolt hole locations. Some aftermarket flywheels are drilled for both 10" and 11".
Thread
Thread Starter
Forum
Replies
Last Post
cajunsf
Clutch, Transmission, Differential, Axle & Transfer Case
0
Aug 23, 2004 04:33 PM
Franken-Truck
Clutch, Transmission, Differential, Axle & Transfer Case
4
Aug 7, 2004 11:42 PM
