Blind Spot alarm…
Thread Starter
|
Mountain Pass
Joined: Feb 2021
Posts: 172
Likes: 43
From: Reno, NV
Blind Spot alarm…
After someone hit it I had my rear left light assembly changed. I got the truck back yesterday and drove home from the body shop without any problem, but today as soon as I started I got ”Blind Spot System Fault” and “Cross Traffic System Fault” alarms. They go away if I press “ok” but they come back after a minute or so, and it keeps doing it.
Of course I tend to think it’s a problem of the new light assembly and radar sensor, but I’m puzzled that it did not do it yesterday…
Any other possibility I can take a look at before bringing it back to the body shop?
Max
———————————————————
2019 F-250 Lariat, 6.2 gas.
Of course I tend to think it’s a problem of the new light assembly and radar sensor, but I’m puzzled that it did not do it yesterday…
Any other possibility I can take a look at before bringing it back to the body shop?
Max
———————————————————
2019 F-250 Lariat, 6.2 gas.
Last edited by iConnect; Dec 11, 2021 at 08:04 PM. Reason: Grammar…
Thread Starter
|
Mountain Pass
Joined: Feb 2021
Posts: 172
Likes: 43
From: Reno, NV
That’s interesting… Is there any instruction/discussion somewhere for that? I’d like to tell them what they need to do…
Thread
Thread Starter
Forum
Replies
Last Post
mooch91
Audio & Video Systems, Navigation, Satellite Radio & Mobile Electronics
1
Dec 17, 2007 10:15 PM
