Rear shims and odd angles
Thread Starter
|
5th Wheeling
Joined: Nov 2021
Posts: 26
Likes: 5
Rear shims and odd angles
After the 22415s install with 2* shims fat part forward, notice the gap between them and the springs. Not flush.
I measured the angles with my phone and the transfer case u joint was about 0* the rear was almost parallel with the drive shaft at about 10*.
Any idea what's going on here?
Thread
Thread Starter
Forum
Replies
Last Post
AmericanROCKBREAD!
1948 - 1956 F1, F100 & Larger F-Series Trucks
35
Jun 29, 2012 11:33 AM
bigredkacy
Clutch, Transmission, Differential, Axle & Transfer Case
5
Dec 23, 2007 07:00 PM
