Still no reverse lites
Thread Starter
|
Tuned
Joined: Mar 2014
Posts: 319
Likes: 18
Still no reverse lites
To Lime GT. I appreciate some of your suggestions, however, I can't move beyond step 1, which you had said, check for power at Fuse #5, which I did, and there is no power there. But, you did'nt say where to look if there ISN'T power there ! So , I am at a standstill again. Any ideas appreciated. By the way, I checked with key on, in run position. Thanks again.
Fleet Mechanic
Joined: Jul 2010
Posts: 1,354
Likes: 31
From: Winnipeg
Ok,here goes: Fuse 113-40amp of BJB (battery junction box) feeds YELLOW wire through Splice S215 (main wiring harness near steering column) to pins B1 and B3 of the ignition switch. Pin B3 goes to pin A3 (RUN position of ignition switch) and out through a RED/BLK wire to Pin 19 (Connector C270A) of CJB (Central Junction Box). Pin 19 feeds Fuse 5-15amp CJB and out to Pin 15 (Connector C270A) CJB to the LT BLU/PNK wire. LT BLU/PNK wire feeds through S112 to Pin 9 of DTR switch; out Pin 11 PNK/BLK of DTR switch to S130 to S405 to reversing Lamps out to BLK wire to S401 to Ground 104 (at left front of engine compartment).
That's the circuit. Pencil and paper and you can draw the circuit which makes it quick to follow.
That's the circuit. Pencil and paper and you can draw the circuit which makes it quick to follow.
Thread Starter
|
Tuned
Joined: Mar 2014
Posts: 319
Likes: 18
Still no reverse lites
Ok,here goes: Fuse 113-40amp of BJB (battery junction box) feeds YELLOW wire through Splice S215 (main wiring harness near steering column) to pins B1 and B3 of the ignition switch. Pin B3 goes to pin A3 (RUN position of ignition switch) and out through a RED/BLK wire to Pin 19 (Connector C270A) of CJB (Central Junction Box). Pin 19 feeds Fuse 5-15amp CJB and out to Pin 15 (Connector C270A) CJB to the LT BLU/PNK wire. LT BLU/PNK wire feeds through S112 to Pin 9 of DTR switch; out Pin 11 PNK/BLK of DTR switch to S130 to S405 to reversing Lamps out to BLK wire to S401 to Ground 104 (at left front of engine compartment).
That's the circuit. Pencil and paper and you can draw the circuit which makes it quick to follow.
That's the circuit. Pencil and paper and you can draw the circuit which makes it quick to follow.
Thread
Thread Starter
Forum
Replies
Last Post
