Totally Stainless Bolt Kit
Thread Starter
|
Tuned
Joined: Jun 2019
Posts: 296
Likes: 112
From: NJ
Totally Stainless Bolt Kit
I purchased their kit for my 49 f1. For the most part the pieces come in big bags labeled for specific areas of the truck. The current bag I am looking at is "inner fender" it has the carriage bolts for the inner and out fenders, 2 3/8 bolts which I assume are inner to cowl, inner fender to rad support bolts and a **** load of 5/16 bolts nuts and washers which I assume will be for fender to grill etc. Possibly lower valance is included in there too. The question I have is the bag has 6 1/4-20 bolts that I cannot figure out where they go as well as 4 larger 5/16 flat washers that I am stumped on.....If you have used this kit or have any ideas I am listening.
Mike
Mike
More Turbo
Joined: May 2004
Posts: 547
Likes: 8
From: BC, Canada
6 - 1/4" x 5/8" NC bolts are used to hold the fan shroud to the radiator.
The large washers could be inner fenders to cowl, 4 of them would be used, top and bottom. Two upper ones are 3/8", two lower ones are 5/16". Mine had rubber washers between inner fenders and cowl.
Terry
The large washers could be inner fenders to cowl, 4 of them would be used, top and bottom. Two upper ones are 3/8", two lower ones are 5/16". Mine had rubber washers between inner fenders and cowl.
Terry
Thread Starter
|
Tuned
Joined: Jun 2019
Posts: 296
Likes: 112
From: NJ
Thanks! I am running an aftermarket rad and electric fan so that makes sense. I do have the 3/8 washers these are in addition to those.
Thread
Thread Starter
Forum
Replies
Last Post
nick83f150
1980 - 1986 Bullnose F100, F150 & Larger F-Series Trucks
2
May 20, 2018 11:01 PM
BoomerPower
1980 - 1986 Bullnose F100, F150 & Larger F-Series Trucks
1
Jan 22, 2005 10:49 PM
joners
1948 - 1956 F1, F100 & Larger F-Series Trucks
2
Dec 1, 2003 05:45 PM
