Hypertech Programmer
Thread Starter
|
New User
Joined: Aug 2003
Posts: 3
Likes: 0
From: Jacksonville, Florida
Hypertech Programmer
I have a 01 F250 PS 7.3. Other than a 6 inch lift and 35 inch tires, it is basically bone stock. My question is this: I used the stage 1 programming and got good results, but can I use stage 2 programming without damaging anything? I've been hearing that the stage 3 programming is the only one that would require a modification on the intake and exhaust, along with the "a" post guages. Any information on this would be greatly appreciated.
By the way, I'm also a Jeepin nut "thats what I need the thruck for" Maybe we could barter information?
Let me know
C ya round the interstate
truckand jeep
By the way, I'm also a Jeepin nut "thats what I need the thruck for" Maybe we could barter information?
Let me know
C ya round the interstate
truckand jeep
Senior User
Joined: Aug 2001
Posts: 300
Likes: 0
From: Kentucky
I use the PPIII from HyperTech and I'm very pleased. It is the 60hp/95-110 ft.lb tork ver.. I called the company to get their info before installing and using mine. I've had it in the system for 65,000 miles and am quite pleased with the performance. I pull a 12,800 lb 5th wheel just about any place I want with it, quite comfortably. I would rather take a little power loss than a lot of engine parts loss. You know what I mean.
Luv My PSD
Bill in KY
HodgeKuter
Luv My PSD
Bill in KY
HodgeKuter
Thread
Thread Starter
Forum
Replies
Last Post
