Seatbelt Question
Thread Starter
|
New User
Joined: Dec 2019
Posts: 11
Likes: 0
Seatbelt Question
I have 75 ford with lap belts (2 points) and I am switching them to a reproduction 3 point set. Figure now that I have a kid should have some safety features 
Has anybody done this? I am looking for the height of the bolt that holds the shoulder clip, also any suggestions on the backing plate? I am thinking of welding a nut onto a plate threading it down through the headliner gap.
Thanks!
Has anybody done this? I am looking for the height of the bolt that holds the shoulder clip, also any suggestions on the backing plate? I am thinking of welding a nut onto a plate threading it down through the headliner gap.Thanks!
Laughing Gas
Joined: Jun 2016
Posts: 855
Likes: 56
From: Des Moines, Washington
Here's my install, I do wish I'd put the upper mount up an inch or 2 higher but they do work fine.
The SuperCab gets new seat belts
Michael
The SuperCab gets new seat belts
Michael
Thread
Thread Starter
Forum
Replies
Last Post
