Driver window not working
Thread Starter
|
Freshman User
Joined: Feb 2020
Posts: 40
Likes: 0
Driver window not working
Happened in the winter and I just thought it was ice or frozen. It's back not moving again I hear window click when I push button for down and up but doesn't move at all. I was thinking motor/regulator any thoughts suggestions. t/u
Logistics Pro
Joined: Jun 2009
Posts: 4,817
Likes: 83
From: Cedar Rapids, IA
What model year is your Explorer? If you're definitely hearing the window click, versus just the switch or a relay, then the issue is probably not the rather typical broken wire between the door and cab. You best bet in the case the issue is not electrical in nature would be to remove the door panel and perform an inspection to see what's binding or not working correctly.
-Rod
-Rod
Thread Starter
|
Freshman User
Joined: Feb 2020
Posts: 40
Likes: 0
2007
What model year is your Explorer? If you're definitely hearing the window click, versus just the switch or a relay, then the issue is probably not the rather typical broken wire between the door and cab. You best bet in the case the issue is not electrical in nature would be to remove the door panel and perform an inspection to see what's binding or not working correctly.
-Rod
-Rod
Thread Starter
|
Freshman User
Joined: Feb 2020
Posts: 40
Likes: 0
Well since i am working from home i went out started it up and the window is working. It did seem to move a little slow at first coming out of weather striping. Could it be due not driving it in a few days and i do have the vent visors that are inside the door making it a little tighter?
Thread Starter
|
Freshman User
Joined: Feb 2020
Posts: 40
Likes: 0
Replaced motor/regulator and the front hole is off the back bracket isn't bent in for the foam part. Going to try to use metal part off of old regulator that connects to window. This is a supposed Dorman part...
Cross-Country
Joined: Dec 2009
Posts: 80
Likes: 3
04 explorer same window problem i figured that the problem is the window just jambs up too tigh against the top of door so now i close the window an just tap the botton down just a light tap enough to lower the window a bit it seem to be a winter problem here in fl so far 3 months no problem wire were all checked i was ready to buy a replacement the last time, an i was tapping the window motor with a hammer in the door then it started working so thats a my theroy !!! an i m still in the testing stage
Thread
Thread Starter
Forum
Replies
Last Post
Fffran
1999 - 2016 Super Duty
0
Oct 26, 2019 12:38 PM
