2012 f550 6.7 pulse ring
Thread Starter
|
New User
Joined: Jun 2019
Posts: 3
Likes: 0
2012 f550 6.7 pulse ring
Just have a quick question sorry if I posted to the wrong spot. Can you see the pulse ring if you pull the CKP sensor, I did that and all I can see is the crankshaft nothing else. I just installed a new long block in it and didn't have this issue before. The vehicle runs good but takes around 10 seconds of cranking to start. Has code p0335.
Last edited by dhsiegler; Jun 19, 2019 at 04:39 PM. Reason: Spelled word wrong
Fleet Mechanic
Joined: Jan 2016
Posts: 1,804
Likes: 113
It will run but cannot determine correct timing during operation. I'm not that familiar with a 6.7. Should the pulse ring have been included with new rebuilt engine? Did you remove it and send it in with your core?
Thread Starter
|
New User
Joined: Jun 2019
Posts: 3
Likes: 0
I think you have to swap it.
From what I read on the internet is that you have to swap it, so it was my fault that I missed it when I swapped the flywheel. This was the very first time I ever touched a 6.7 I learned a lot about it.
Thread
Thread Starter
Forum
Replies
Last Post
83sd
Clutch, Transmission, Differential, Axle & Transfer Case
1
Sep 30, 2016 04:06 PM
yellow72f100
Small Block V8 (221, 260, 289, 5.0/302, 5.8/351W)
3
Dec 16, 2006 07:35 PM
