8BA weaping heads
Thread Starter
|
Cargo Master
Joined: Nov 2014
Posts: 2,442
Likes: 256
8BA weaping heads
The head gaskets on our v8 are weaping. I have torqued them down twice already after bringing it up to temperature but I did not torque them down again after driving it for the first time and putting a load on the engine. My first step is to torque them down again. I have been using 55 lbs as my final torque but should I go higher? Using stock 8BA heads milled and copper gaskets sprayed with copper sealant.
JB
JB
Thread
Thread Starter
Forum
Replies
Last Post
ford-lover1995
Small Block V8 (221, 260, 289, 5.0/302, 5.8/351W)
3
Mar 13, 2011 11:26 AM
robertskunfused
FE & FT Big Block V8 (332, 352, 360, 390, 406, 410, 427, 428)
2
Feb 6, 2003 10:52 PM
