Dash clock
Thread Starter
|
Mountain Pass
Joined: May 2012
Posts: 186
Likes: 1
From: Voorhees NJ
Dash clock
Had to replace battery. Now I can’t reset my dash clock. Push the buttons to reset time and date, but it won’t change. It’s been difficult before, but now it’s impossible. Any help is appreciated
Freshman User
Joined: Sep 2018
Posts: 34
Likes: 2
Just ran into this just this past weekend. Yes do try to push "hard" or wiggle them around. If that still does not yield results, remove the radio bezel, remove the entire clock assembly, then take a very slim piece of sandpaper and wedge the sandpaper between the flat silver piece that is raised off the back of the circuit board that is between the buttons and the circuit board. The buttons push this flat, very small metal piece down and it makes contact on the back of the circuit board to change time, date, etc. I tried the wiggle and push method before and worked, but until this past weekend (time change) it no longer worked. After I used the sandpaper to knock off the corrosion on the metal tabs, I was good to go!
Thread
Thread Starter
Forum
Replies
Last Post
Anafiel
1980 - 1986 Bullnose F100, F150 & Larger F-Series Trucks
10
Feb 9, 2014 07:04 PM
dnmyoda
1980 - 1986 Bullnose F100, F150 & Larger F-Series Trucks
16
Feb 9, 2004 12:42 AM
