Hi, I got an E-250 Cargo Van with a 4r100 and 5.4 v8 to replace my dead E-150 with a 302 and AOD.

I'm looking into adding a trans temp gauge, I have my gauge already, where is a good place to put it BESIDES the A pillar?

 

I also hate those A-pillar mounts for gauges---seems like a forward vision obstruction I can do without. I'm partial to two different gauge mounts from Auto Meter, one places a single or dual gauge right on the steering column (partially interfering with the standard instrument cluster) part number 15004 or one of their overhead consoles, part numbers 18016 18017, 18018.

I have one of the 15004 mounts and 18018, both unused and up for sale if interested. Not "cheap" but better than full retail.

 

Will they fit my E-250, thats the only question, if it's a yes, Can you send me some pic's?

 

They will definitely fit----have one of the triple's installed right now, the quad not being the best as the visors obscure the two outside gauges if installed.

Let me cruise my photos of these things in place---will be just a bit so be patient for a few hours.

FWIW Auto Meter does us E-Series owners a disservice listing so much of their compatible mounts as Dodge/Ram specific. A lot of the late 90's and 2000 F-Series fit our vans too.

Back in a bit!

 

THANKYOU SO MUCH

I'm gonna buy one or the other off of you once we get this squared away

 

Okay here's what I have but the triple pod is a stock image (left my camera somewhere have only a crappy cell phone image of the quad console, column mount is from a while ago. Each pod is new, uninstalled and ready to install. The column mount simply fits over top of the existing column but the ignition key cylinder does need to be temporarily removed. PM me if interested.

Thanks