Upper and Lower Ball Joints
Lead Driver
Joined: Jul 2003
Posts: 7,404
Likes: 52
From: Wheatland, Mo
If you were local to me I would say bring it on over. I have the press, air tools, etc to get it done. Done mine about 3 times and many others for friends. Even have the beer and specialty tool for seating the big bearing seal. 
You tube has a lot of info but as mentioned, many have edited the video for time and a lot of the cussing and arguing. Just make a list of everything for parts and tools and make sure you have it all before starting. You don’t need to buy a press if you don’t want. Machine shops and many repair shops will press out old and press in new for you for about $20 a side. Worth the money if you don’t want to buy the tools.
You tube has a lot of info but as mentioned, many have edited the video for time and a lot of the cussing and arguing. Just make a list of everything for parts and tools and make sure you have it all before starting. You don’t need to buy a press if you don’t want. Machine shops and many repair shops will press out old and press in new for you for about $20 a side. Worth the money if you don’t want to buy the tools.
Thread
Thread Starter
Forum
Replies
Last Post
Apocalypse
Excursion - King of SUVs
36
Aug 16, 2013 10:51 PM
Kalvin
1987 - 1996 F150 & Larger F-Series Trucks
1
Oct 18, 2003 04:11 AM
