O2 Sensor

Reply Subscribe

Thread Tools

Search this Thread

Oct 22, 2017 | 07:48 PM

BWD444

Thread Starter

Mountain Pass

Joined: Dec 2016

Posts: 130

Likes: 0

O2 Sensor

I swapped a 1995 4.9l into a 1997 F350 that had a 5.8l and an E4OD tranny. I have it running and removed the air injection and cats as I do not need them in my state. I left the EGR and O2 sensor. I had to swap the underhood wire harness to get the engine to run as pinouts were different. I now have two O2 sensor plugs. One on the tranny that was original to the truck and a new one on the new underhood harness that runs down from the right fender near the starter solenoid. I plugged into the latter as that is what the 4.9l used is this right or should I use the one on the tranny? I only have one O2 sensor.

Thanks, Brian

Oct 23, 2017 | 05:57 AM

Franklin2

Moderator

Joined: Jan 2001

Posts: 56,984

Likes: 2,738

From: Virginia

The wiring harness you used was a 1995 with a 4.9? If so, does a 1995 4.9 use two O2 sensors? Some of the engines did.

Oct 23, 2017 | 08:07 AM