Is there a member that would like to perform an AE Scan on my 02' RWD f250 7.3? Lost an injector on the way back from Temple this morning. I just need to know which one. I use Dash Command for Iphone and it is showing P1316.

Thanks in advance.

 

You don't need AE. You can download FORScan, and/or use a multimeter with the UVCH link in my signature (visible on the full FTE site, not the mobile site).

 

Thank you sir!

 

Ohm readings: #1 3.1 #2 3.1 #3 3.2 #4 3.0(was 12.9 found the problem, repaired loose wire)#5 2.8 #6 3.0 #7 3.1 #8 3.1.

Still getting P1119, P1316 codes.

 

I'm betting you're running better now, but you are concerned about codes. I don't troubleshoot by codes alone, because so many false codes pop with these rigs on a regular basis.

P1119 is a Manifold Air Temperature sensor issue. This can effect fuel trim for sure, but I am unsure what else.

P1316 is little more than a throat clearing from the IDM, like a call to attention. You need to run a KOER to poll the IDM as if to ask "Whazzup?" This is the IDM's golden moment to whine about it's specific ailments like Grandpa discusses his stool consistency.

 

Tugly, I've moved this to a new thread and its running about the same. Although I just noticed that I am now getting a "U" PCM code didn't log it though, but I will shortly.

Thanks!

 

New codes P0237 U1262 B1352

 

Hello everyone,
i have access to a AE but I need to get a laptop. What is the best windows for the AE?
Thanks for your help.

 

There are different versions of AE, but I use windows 7 on an older laptop for software that needs to interface with stuff. A few versions of AE require a dongle, so the laptop needs at least 2 USB ports for those versions.