Need some help. My daughter. Bought a 1996 Bronco. The Bronco will start and then stall. Or, run for a bit and then stall when trying to back out of the driveway.
Things replaced already:
ICM
wires
coil
both front O2 sensors
trans filter
I tried to use a code retriever but all I get are incomplete tests.

any ideas?

 

That's frustrating, you need codes. The EGR can cause it to stumble when taking off, but usually doesn't kill it in my experience. I would try a different code reader.

 

It being a 96 its probably OBDII, you need a code reader for that.

is there a CEL on when its running.

 

Based the OP's first post statement "I tried to use a code retriever but all I get are incomplete tests." that implies they have the proper code reader and the only codes indicate the drive cycle monitors are not fully completed.

It's time to check the fuel pressure IMHO.