Extang Solid Fold 2.0 Toolbox Cover Not Fitting
#1
Extang Solid Fold 2.0 Toolbox Cover Not Fitting
Does anyone have the Extang Solid Fold 2.0 Toolbox Cover for their 2017 superduty? I ordered two and the track that goes against the toolbox is too wide on both covers.
Attached are some pictures so you can see the terrible fit. The mounting holes on the track against toolbox are about 1-2" too wide.
Im running a standard 20" Weatherguard toolbox.
You will also notice the latch that secures the actual cover to the bed rail next to toolbox lands where the body molding does not allow you to clip/attach to the rail.
If anyone has figured out a work around to these problems please let me know.
Attached are some pictures so you can see the terrible fit. The mounting holes on the track against toolbox are about 1-2" too wide.
Im running a standard 20" Weatherguard toolbox.
You will also notice the latch that secures the actual cover to the bed rail next to toolbox lands where the body molding does not allow you to clip/attach to the rail.
If anyone has figured out a work around to these problems please let me know.
Thread
Thread Starter
Forum
Replies
Last Post
00Ranger4x4
1983 - 2012 Ranger & B-Series
4
09-28-2002 10:10 PM